Communication
2.2 PROFINET communication
SIMOCODE pro - Communication
74 Function Manual, 11/2018, A5E40508495002A/RS-AC/003
Data block "ChannelErrorType"
The ChannelErrorType does not indicate the "Fault" status. For this purpose, there is the
PNIO diagnostics status for the raised alarm: Maintenance Required, Maintenance
Demanded, Failure.
Table 2- 25 ChannelErrorType
1)
0x0010 Parameterization error
1)
Error of the PROFINET interface
0x8000 Data transmission not possible
Loss of synchronization (bus end)
Loss of clock synchronization (device end)
Slave-to-slave traffic connection error
Error in network component
0x1008 Antivalence
Operational protection OFF (OPO)
0x1023 Overload + Loss of phase
EM/EM+ External ground fault
To Next Page
Loading...
Need help?
General
