Introduction
1.3 Accessibility options
1-18
SINUMERIK 802D sl Operation and Programming Nibbling (BP-N), 06/2006 Edition
6FC5 398-3CP10-0BA0
1.3.3 Hotkeys
This operator control can be used to select, copy, cut and delete texts using special key
commands. These functions are available both for the part program editor and for input
fields.
<CTRL+C> Copy
<CTRL+B> Select
<CTRL+X> Cut
<CTRL+V> Paste
<ALT+L> Switch between uppercase/lowercase letters
<ALT+H> Use this key combination or press the Info key to call the help system
1.3.4 Copying and pasting files
In the Program Manager area (Chapter 6) and with the Start-up files function (Section
7.1), files or even complete directories can be copied into another directory or to another
drive using the softkey functions <Copy> and <Paste>. When doing so, the <Copy> func-
tion enters the references to the files or directories in a list which is subsequently executed
by the <Paste> function. This function will perform the actual copying process.
The list is kept until a new copying process overwrites this list.
Special situation:
If the RS232 interface has been selected as the data target, <Paste> will be replaced by the
<Send> softkey function. When reading in files (Receive <softkey>), it is not necessary to
specify a target, since the name of the target directory is not contained in the data flow.
To Next Page
Loading...
Need help?
General
