Siemens SINUMERIK 802D sl Operation And Programming Manual

AUTOMATIC Mode
5.2 Block search “Machine” operating area
5-61
SINUMERIK 802D sl Operation and Programming Nibbling (BP-N), 06/2006 Edition
6FC5 398-3CP10-0BA0
5.2 Block search “Machine” operating area
Operating sequence
Prerequisite: The required program has already been selected (cf. Section 5.1) and the con-
trol system is in the RESET condition.
The block search function provides advance of the program to the required block in the part
program. The search target is set by positioning the cursor bar directly on the required block
in the part program.
Fig. 5-6 Block search
Block search to the block start
Block search to the end of the block
Block search without calculation
The interruption point is loaded.
This softkey opens a dialog box where you can enter the number of the line or searched
terms.
Block
search
To
contour
To
end point
Without
calcul.
Interr.
Find

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English