Siemens SINUMERIK 802D sl Operation And Programming Manual

AUTOMATIC Mode
5.6 Execution from external
5-64
SINUMERIK 802D sl Operation and Programming Nibbling (BP-N), 06/2006 Edition
6FC5 398-3CP10-0BA0
5.6 Execution from external
Functionality
Use this softkey to transmit an external program to the control system via the CF card;
pressing <NC START> will start this program immediately.
While the contents of the buffer memory are being processed, the blocks are reloaded auto-
matically.
Operating sequence when executing a program from the CF card
Prerequisite: The control system is in the RESET condition.
Select the AUTOMATIC mode and the Program Manager using the appropriate keys on the
machine control panel.
Press the softkey and select the program to be executed using the cursor.
Press the softkey.
The program is transmitted into the buffer memory and selected and displayed in the “Pro-
gram Selection” automatically.
Press <NC START> to start the program execution. The program is reloaded continuously.
At the end of the program or in case of RESET, the program is automatically removed from
the control system.
Customer
CF card
Execution
from external

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English