Siemens SINUMERIK 802D sl Operation And Programming Manual

Programming
8.2 Positional data
8-146
SINUMERIK 802D sl Operation and Programming Nibbling (BP-N), 06/2006 Edition
6FC5 398-3CP10-0BA0
Programming example
Mirroring in different coordinate axes with influence to an enabled tool radius compensation and G2/G3:
...
N10 G17 ; X/Y plane,
N20 L10 ; Programmed contour
N30 MIRROR X0 ; The direction is changed in X
N40 L10 ; Mirrored contour
N50 MIRROR Y0 ; The direction is changed in Y
N60 L10
N70 AMIRROR X0 ; Mirroring once more, but now in X
N80 L10 ; Contour mirrored twice
N90 MIRROR ; Mirroring OFF.
...
Subroutine call – see Section 8.9 “Subroutine technique ”
8.2.9 Workpiece clamping – settable work offset:
G54 to G59, G500, G53, G153
Functionality
The settable work offset specifies the position of the workpiece zero on the machine (offset
of the workpiece zero with respect to the machine zero). This offset is determined upon
clamping of the workpiece into the machine and must be entered in the corresponding data
field by the operator. The value is activated by the program by selection from six possible
groupings: G54 to G59.
Note: Workpiece clamping at an angle is possible by entering the angles of rotation around
the machine axes. These rotation portions are activated with the offset G54 to G59.
For information on operation, see Section “Setting/changing the work offset”
Programming
G54 ; 1st settable work offset
G55 ; 2nd settable work offset
G56 ; 3rd settable work offset
G57 ; 4th settable work offset
G58 ; 5th settable work offset
G59 ; 6th settable work offset
G500 ; Settable work offset OFF – modal
G53 ; Settable work offset OFF – non–modal,
; Suppresses also the programmable offset
G153 ; The same as G53, but suppresses additionally base frame

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English