10.03
6-194
Siemens AG, 2003. All rights reserved
SINUMERIK 840D/SIMODRIVE 611 digital, HLA Module (FBHLA) - 10.03 Edition
NC not ready.
Mode group not ready.
NC stopped in response to alarm.
NC start disable.
The NC switches to follow-up mode.
Alarm display.
Interface signals are set.
Please inform the authorized personnel/service department.
Set the drive basic clock cycle to the same value for both axes.
Switch control system OFF and ON again.
Axis %1, drive %2 position controller clock cycle axially unequal
%1 = NC axis number
%2 = drive number
The position controller clock cycle is different for the two axes on a 2-axis
module.
This alarm can only occur with OEM users having the 611D drives without the
standard NCK interface. In this instance, it would be possible to transfer differ-
ent axial position controller clock cycles to the 611D module.
NC not ready.
Mode group not ready.
NC stopped in response to alarm.
NC start disable.
The NC switches to follow-up mode.
Alarm display.
Interface signals are set.
Please inform the authorized personnel/service department.
Set the position controller cycle to the same value for both axes.
Switch control system OFF and ON again.
Axis %1, drive %2 lead time for position controller invalid
%1 = NC axis number
%2 = drive number
The position controller computing time reduction specified by the NC must be
shorter than the position controller cycle. The offset must be an integer multiple
of the speed controller cycle.
NC not ready.
Mode group not ready.
NC stopped in response to alarm.
NC start disable.
The NC switches to follow-up mode.
Alarm display.
Interface signals are set.
Please inform the authorized personnel/service department.
MD 10082: CTROUT_LEAD_TIME (offset in setpoint transfer time).
Switch control system OFF and ON again.
Response
Remedy
Continue program
300 710
Explanation
Response
Remedy
Continue program
300 713
Explanation
Response
Remedy
Continue program
02.99
To Next Page
Loading...
Need help?
General
