Siemens TIM 4R-IE DNP3 - Page 155

The SINAUT Configuration Tool
6.5 The Subscriber Administration
TIM DNP3
System Manual, 06/2014, C79000-G8976-C253-03
155
●
SINAUT connected
Specifies whether or not a telecontrol connection was configured for the subscriber.
●
SINAUT library
Name of the TD7 block library for CPUs (not for DNP3) or for TD7onTIM-compliant TIM
modules.
You set the parameters for some subscriber-related properties in the "Properties of
subscriber" dialog, see section The "Properties of Subscriber" dialog (Page 155).
Parameter area
The dialogs below the subscriber list are used for configuring the TD7 software for the TIM
(TD7onTIM).
6.5.3
The "Properties of Subscriber" dialog
6.5.3.1
Parameter overview
Overview of the tabs of the Properties of subscriber dialog
By double-clicking on a subscriber number or by selecting the Edit / Properties menu, the
Properties of subscriber dialog is displayed. The content and number of the tabs of the
Properties of subscriber dialog depend on the subscriber type.
Table 6- 2 Overview of the Properties dialog tabs according to subscriber type
Tab
CPU
TIM
Other station,
SIMATIC S5,
PC station, PG
Names of follow-up dialogs
Note
Info
yes
yes
yes
-
-
Partner
yes yes DNP3 master
station
- -
Connections
yes yes - Properties - Local
Connection
-
Polling List
-
-
-
Properties - Poll list entry
-
DB
Configuration
yes - - - Not relevant for DNP3 because the
CPU does not require any telecontrol-
specific DBs.
Library
Information
yes - - - Not relevant for DNP3 (information on
TD7onCPU).