Siemens TIM 4R-IE DNP3 - Page 169

The SINAUT Configuration Tool
6.6 TD7onTIM
TIM DNP3
System Manual, 06/2014, C79000-G8976-C253-03
169
Object
group
Variation
Format according
to the DNP3
specification
Station type
TD7onTIM object
S7 data
type
DNP3 level of the
partner ***
*
The object groups 21, 23, 40 and 42 are formed in the stations only by being polled by a master or by internally generated
events.
**
These objects are used to mirror back values from the station to the master station, see the following reference.
***
If there is no information included about the DNP3 level, the object is supported by all implementation levels. Otherwise
the required implementation level of the communications partner is specified.
****
The following objects are always sent by the master TIM with the control code "DIRECT_OPERATE": Bin08X_S (12),
Cmd01B_S (12), Par12D_S (41), Set01W_S (41)
Mirroring back: You will find an description of the function in the section in the section
Mirroring back (Page 186).
The DNP3 implementation level is specified for every subscriber in the SINAUT configuration
tool:
> Subscriber Administration > TIMs with TD7onTIM > All Destination Subscribers
You will find a table sorted according to TD7onTIM objects in the section Objects: Overview
table (Page 180).
TD7onTIM objects not supported
The "Par12x1D_R" object is not supported for the DNP3 protocol.
6.6.3
Configuring TD7onTIM (overview)
Configuring the TD7 software
The configuration of TD7onTIM is set in the subscriber administration of the SINAUT
configuration tool in the following steps:
1. Parameter assignment / configuration of the basic settings for each TIM with TD7onTIM
2. Specifying the parameters specific to the destination subscribers
3. Adding objects:
The objects are grouped together in the TD7onTIM library that is called from the
subscriber administration.
– System objects
Using the system objects, system information is displayed and communications
functions are activated and set.
– Data objects
Which data is to be sent or received is configured using standardized data objects.
– MODBUS-specific objects
MODBUS-specific properties are configured with these objects.