Diagnostics and upkeep
7.3 SINAUT diagnostics and service tool
TIM DNP3
292 System Manual, 06/2014, C79000-G8976-C253-03
Bit shift error in P bus communication.
Diagnostic interrupt cannot be sent. Module is not enabled on P bus.
Diagnostic interrupt cannot be sent. Diagnostic interrupt is not enabled on P bus.
SDB0.SDB cannot be opened. File overwritten without comparison.
SDB0.SDB cannot be created.
SDB0.SDB cannot be written.
BUS3-ASIC could not be initialized.
SDB5.SDB cannot be opened. File overwritten without comparison.
SDB5.SDB cannot be created.
SDB5.SDB cannot be written.
Messages from the SDB handler
Installation of the SDB handler aborted.
SDB could not be deleted.
SDB information of hierarchy 1 not available.
F560 06E5 SDB information of hierarchy 2 not available.
SDB information of hierarchy 3 not available.
F560 06E7 Error chaining SDBs.
SDB handler: Unknown job.
Control instruction unknown.
Error occurred during firmware update.
0700
Entering state: TD7 installation started.
Exiting state: TD7 installation ready.
SecIntervall task was not started.
TD7_ObjectAdmin task was not started.
The path for SDB files could not be opened.
The TD7 SDB could not be found.
The TD7 SDB could not be opened.
Header with incorrect length of block ID.
TD7-SDB: No TD7 parameters found.
TD7-SDB: Block not found.
TD7-SDB: T4T_MAINHDR has incorrect length.
TD7-SDB: T4T_SUBDATA has incorrect length.
F560 070E TD7-SDB: Unknown format in a destination subscriber block.
TD7-SDB: Number of partner blocks incorrect.
F560 0712 TD7-SDB: Unknown format in a partner block.
To Next Page
Loading...
