Glossary
TIM DNP3
System Manual, 12/2015, C79000-G8976-C253-04
347
See also Image memory / send buffer
A setpoint is a selected digital or analog value that is transmitted once after the value has
been set. The entered value is recalculated when necessary. A setpoint is always
transmitted as 1 word. At the receiving end, the setpoint can either the output directly to the
process as an analog signal (for example to an external controller) or the value is made
available to the local program for further processing (setpoint for internal controller, limit
value, threshold value etc.).
Setpoint and command input are interlocked for safety reasons; in other words, a setpoint
input cannot be made at the same time as a command input. In this case, the acquisition
program recognizes an error. Neither the setpoint nor the command are transmitted.
Siemens automation system
SIemens Network AUTomation
Telecontrol system based on SIMATIC S7
SINAUT configuration software
→
SINAUT engineering software
SINAUT configuration tool
→
SINAUT engineering software
SINAUT diagnostics and service tool
→
SINAUT engineering software
SINAUT engineering software
Software package for TIM modules consisting of:
● SINAUT configuration and diagnostics software consisting of:
– SINAUT configuration software
– SINAUT diagnostics and service tool
● SINAUT TD7 block library (for the CPU - cannot be used for the DNP3 TIM)
To Next Page
Loading...
Need help?
General
