Events and faults 13.4 Messages and troubleshooting measures
Edition 07/2007 Technical Description DTCO 1381 13 - 29
TD00.1381.00 132 102
p $ TFOTPSáGBVMU 8000002380 Error during sensor communication.
Possible causes
•No data signal (B4)
• KITAS 2171 not paired with the DTCO 1381
Measures
– Check KITAS 2171 sensor cable and correct the following
if necessary:
a) Pin assignment
b) Connection (imperfect contact)
c) Specifications
– Check KITAS 2171.
– Check DTCO 1381 (input B4).
– Use a test device to pair the KITAS 2171 with the DTCO
1381.
Replace any defective components.
1)
dj ESJWJOHáXJUIPVUá
DBSE
8000001260 Driving without or without valid driver or workshop card in
card slot 1 or driving with an invalid card combination in
card slot 1 and 2.
Measures
– Check whether a valid driver or workshop card is in card
slot 1 and insert a valid card if necessary.
– Check whether a company card or control card is inserted
in the card slot and eject the card if necessary.
jd
jd
JOTFSUJPOáXIJMFá
ESJWJOH
4000000200
4000000300
A tachograph card was inserted after driving had com-
menced.
Possible causes
• Motion sensor impulses detected before correct reading-
in of a tachograph card
Measures
– In general, insert tachograph cards only when the
vehicle is motionless.
No steps must be taken.
DTCO 1381 display
Picto. AP Error text MC Error code Meaning, cause and measures
1)
These warning messages will be displayed repetitively every hour until the cause is withdrawn.
2)
These warning messages are not saved in the date memory during calibration mode.
To Next Page
Loading...
