9-26
4007ES Panel Programmer Manual (579-1167)
Custom Control, Continued
Suppression
Release Use
Cases
Initial data window
• Program#: 3
Note: It is always 3 on a 4007ES.
• Check Enhanced Power Supply because we have an IDNAC channel.
• Uncheck Cross Zone (Dual Detector).
Note: Without cross zone the audible notification automatically defaults to Fast March Time
(March120).
Abort Logic Window
• Set Immediate Release (No Delay).
Timer Configurations
• Uncheck Manual Release to set it a 0.
• Uncheck Detector Release Delay to set it at 0.
Hazard Area Lists window
• Press Manual Release Points and select the manual release point at M1-11-0.
• Press Automatic Release Points and select Automatic Release Points at M1-18-0.
• Do not add any devices to Abort Switches.
• Do not add any devices to Release Warning Points.
• Press Suppression Dump Points and select SIG3 and M1-36-0.
• Press Release Notification Audible NACs and select SIG913.
• Press Release Notification Visible NACs and select SIG915.
Table 9-6 describes actions and their corresponding responses.
Table 9-6. Immediate Release, Actions and Responses
Action Response
First detector is
triggered
RELSIG turns on steady. RELVIS turns on. SUPRELS NAC turns on steady and
SRP output turns on steady.
To Next Page
Loading...
