Smipack FP6000CS - Predispositions by the Customer; Referential Standards

2 - General information
10
2.3 Predispositions by the customer
Are provided by the customer:
• the predisposition of a suitable place according to local regulations in force governing
health and safety in the workplace.
• any possible building work.
• the machine positioning in a dry, clean and free of obstructions area. The operator and
maintenance staff must have a long area around the perimeter of the installation with a
minimum width of 1,5 m in which it is possible to perform the driving or maintenance
operations on the machine in safe mode.
• the electrical system predisposition to the feeding point of the machine. The electrical
system must be equipped with a earthing suitable to the power absorbed by the machine
and circuit-breakers upstream of the line according to current standards in the place of
installation.
• the set-up for the compressed air supply required for the operation of any optional machine
features. In this regard, the compressed air must be clean since the presence of impurities
contained in the air coming from the compressor and condensed humidity favour the wear
of the seals and of the relative sliding surfaces compromising the durability of the pneumatic
components.
2.4 Referential standards
For the design and construction of the machine were observed to the fulfilment the
requirements of safety the following standards:
European Directives applied to the equipment and/or the assembly:
• 2006/42/EC - Directive concerning the approximation of the laws of Member states relating
to machinery.
• 2014/35/EU - Directive concerning low voltage.
• 2014/30/EU - Directive concerning electromagnetic compatibility.
Technical standards applied to the equipment and/or the assembly:
• EN ISO 12100:2010 - Safety of machinery - General design principles - Risk assessment
and risk reduction.
• EN ISO 13849-1:2016 - Safety of machinery - Safety-related parts of control systems - Part
1: general principles for design.
• EN IEC 60204-1:2006 - Safety of machinery - Electrical equipment of machines - Part 1:
general rules.