41
7.6.4 Operating controls via software
Each time the machine is switched on performs controls to verify some operating positions
(sealing bar movement) by means of a self-calibration prodecure.
7.7 Safety pictograms
Near some particular zones of the machine, some pictograms were placed in order to recall
the attention of the operators concerning the precautions required to avoid dangers. In order
to have greater understanding of the symbols used, the main ones are described hereafter.
In case of damage of the pictograms stickers bearing obligations, prohibitions and regulations
of the machine proceed to remplace them. For the correct position of the pictograms see the
attached manual with SPARE PARTS LIST spare parts list manual in section SAFETY
PICTOGRAMS.
DANGER DUE TO THE HIGH VOLTAGE ZONE WITH RISK OF
ELECTROCUTION INSIDE ELECTRICAL CONTROL BOARD
CUTTING DANGER - PAY ATTENTION TO YOUR HANDS
BURNING DANGER DUE TO CONTACT WITH HIGH
TEMPERATURE SURFACES
CRUSHING DANGER
MOVING PARTS DANGER
To Next Page
Loading...
