10 - Cleaning and maintenance
110
10.6 Ordinary maintenance interventions
S10.5.4 FILM CONFORMATION SQUARES
MACHINE STATUS: machine in stop
FREQUENCY: monthly
REQUIRED MATERIAL: common grease
PROCEDURE:
Lubricate the rods that the film conformation squares
travel along.
S10.6 GENERAL CLEANING
S10.6.1 - CLEANING OF PROTECTIONS
MACHINE STATUS: machine in stop
FREQUENCY: daily
Using a cloth dampened with water,
clean the protections, especially the
plexiglas ones, and remove any film
residues that have settled on the
machine’s conveyor belts.
To Next Page
Loading...
