8 - Preparing the machine for use
52
8.3 Positioning the infeed conveyor belt
Act on the handwheel (B) to position the infeed belt depending on the width (L) of the product
so that it is limited by the guide (2) previously adjusted and the external guide (5).
8.4 Adjustment of reel-holder and unwinder unit
8.4.1 Positioning the film
>FP6000
Make sure you have adjusted the height of the
top square. Position the stop (C) so that it
remains a distance “X” from the tip of the top
square equal to approximately half the height
of the product to be wrapped.
Place the film reel against the stop (C) whit the
open end towards machine outfeed
independently of the unwinding direction and
delimiting it on the opposte sidewith the stop
(D). Lock the two stops by means of the
handles (7).
To Next Page
Loading...
