GENERAL
Page GENERAL-30 Z001019/0_8_Octobre 2011
SERVICE MANUAL MARINE ENGINES
ToC
2) sticker for Maintenance Log of Operation,
Maintenance and Warranty Manual Z001022-0 (sticker
incl. in corresponding Preservation Service Kit)
- see ill.7
NOTE: This preservation procedure must be done every year
and ensures that all of the air ways systems, rawwater
systems, oil system and the cylinders are protected
against corrosion.
This procedure is repeatable up to a maximum of
two times, giving a shelf life of up to three years
(36 months).
After 3 years stocking, starting from STEYR
MOTORS manufacturing date (see ill. 6), engine
must be put into operation for BASE ENGINE
WARRANTY approval. However preservation
procedure can be continued every year after 3
years stocking without BASE ENGINE WARRANTY
approval from STEYR MOTORS.
NOTE: When commissioning or running an engine that has
been preserved as stated above the engine will run
roughly and smoke for the first few minutes. Do not be
alarmed as this is normal until the deposits of the
preservation materials have cleared.
68
Sticker of 1
st
preservation
(refer to Installation Manual P/N Z001007-0/
Chapter 18/Installation and pre-delivery
)troper noitcepsni
Date:
50 h Service
Made by:
Date:
300 h Service
Made by:
Date:
600 h Service
Made by:
Date:
900 h Service
Made by:
Date:
MAINTENANCE LOG
Sticker of 2
nd
preservation
Date:
Date:
150 h Service
Made by:
Date:
450 h Service
Made by:
Date:
750 h Service
Made by:
Date:
1,050 h Service
Made by:
Date:
Sticker of 3
rd
preservation
Date: