Stihl MS 362 - Page 75

74 MS 362, MS 362 C
: Pull the wires out of the guides
(arrows).
: Take out the screws (arrows).
: Remove the air guide shroud (1)
and turn it to one side.
: Take the wire (1) with insulating
tube (2) out of the guides
(arrows).
0001RA355 TG0001RA242 TG
1
0001RA243 TG
1
2
: Pull the handle heating wire (1)
out of the insulating tube (2).
: Pull the wiring harness through
the rubber grommet (1) and out of
the air guide shroud.
: Pull the wire (1) out of the
insulating tube (2).
– Remove the handlebar.
0001RA244 TG
2
1
0001RA262 TG
1
0001RA390 TG
2
1
: Pull off the plastic sleeve (2).
: Take out the screw (1).
: Pull out the handlebar
stiffener (1).
– Check the stiffener and
handlebar and replace if
necessary.
– Test the handle heating system,
b 13.7.1
– Push on the plastic sleeve.
– Reassemble in the reverse
sequence.
0001RA245 TG
1
2
0001RA246 TG
1