Why I am getting error saving more than 4GB files to the USB on Stryker Medical Equipment?
If you're having trouble saving more than 4GB files to the USB on Stryker Medical Equipment, ensure that the USB is formatted as NTFS, because FAT32 does not support file sizes larger than 4GB.
What to do if Stryker Medical Equipment SDC3 does not recognize an SFB or FireWire device?
If the SDC3 does not recognize an SFB/FireWire device, follow these steps: 1. Set the SDC3 power to off. 2. Connect the SFB/FireWire cable to both the device and the SDC3. 3. Set the SDC3 power to on.
What to do for error disk corrupt on Stryker SDC3?
If you encounter the message 'Error: Disk corrupt. Please try again...' on Stryker Medical Equipment, it means the media is corrupt. Insert a new disc to continue.
Why is the annotation list blank on Stryker Measuring Instruments?
If the annotation list is blank on your Stryker Measuring Instruments, ensure that a procedure is selected in the Patient information screen to enable the annotation list.
What to do if list limit reached on Stryker SDC3?
If the list limit has been reached on your Stryker Medical Equipment, it means the maximum number of cases permitted has been reached. Delete older entries in the list.
What to do if Stryker Measuring Instruments says 'USB space insufficient'?
If you receive a 'USB space insufficient' error while using Stryker Measuring Instruments, make sure that there is available free space on the USB media.
What to do when Stryker Measuring Instruments video limit reached?
If you've reached the video limit on your Stryker Measuring Instruments, start a new case to capture more videos.
What to do if Stryker Measuring Instruments has error upgrading software?
If you encounter an error while upgrading the software on Stryker Measuring Instruments, insert the upgrade dongle in the save screen.
How to resolve no live video PIP on monitor issue with Stryker SDC3 Medical Equipment?
Check the cable connections. Make sure that the camera is powered on. Make sure that the proper video source is selected. Make sure that the monitor OSD PIP is enabled via the application.
What to do if there is no live video in PIP on preview on Stryker SDC3?
Check the cable connections, ensure the camera is powered on, verify the correct video source is selected, and confirm you are in PIP mode.
Important warnings and cautions for safe operation and device protection.
Capturing still images and recording video from a single camera source.
Recording and viewing video from two sources simultaneously (PIP, Synchronized, Independent).
Configuring FTP, network adapters, Wi-Fi, streaming, and share settings.
Configuring Studio3, DICOM, Stryker Link, Cloud, PowerShare, and EMR integration.
General| Display | LCD |
|---|---|
| Screen Size | 15" |
| Resolution | 1024 x 768 (XGA) |
| Connectivity | Ethernet |
| Supported File Formats | JPEG, BMP |
| Category | Medical Equipment |
| Video Output | DVI |
| Touchscreen | No |
To Next Page
