Chapter 9 Solaris 10 Predictive Self-Healing and Solaris Diagnostics 9-9
The following example shows output for the prtdiag command in verbose mode.
9.5.3 prtconf Command
Similar to the show-devs command run at the ok prompt, the prtconf command
displays the devices that are configured for the Sun Ultra 45 or Ultra 25 workstation.
The prtconf command identifies hardware that is recognized by the Solaris OS. If
hardware is not suspected of being bad, yet software applications are having trouble
with the hardware, the prtconf command can indicate if the Solaris software
recognizes the hardware and if a driver for the hardware is loaded.
# /usr/platform/sun4u/sbin/prtdiag -v
System Configuration: Sun Microsystems sun4u Sun Ultra 45 or Ultra 25 workstation
System clock frequency: 160 MHZ
Memory size: 1GB
. . .
============================ Environmental Status ============================
Fan Speeds:
---------------------------------------------
Location Sensor Status Speed
---------------------------------------------
F2 CPU okay 3183rpm
F1 Intake okay 2280rpm
F0 Outtake okay 2280rpm
Temperature sensors:
-----------------------------------------------------------------------------
Location Sensor Temperature Lo LoWarn HiWarn Hi Status
-----------------------------------------------------------------------------
MB/0 Die 68C -10C 0C 95C 100C okay
MB Ambient 37C -10C 0C 70C 75C okay
MB Ambient 30C -11C 0C 60C 70C okay
================================ HW Revisions ================================
ASIC Revisions:
-------------------------------------------------------------------
Path Device Status Revision
-------------------------------------------------------------------
/pci@1e,600000 pci108e,a801 okay 4
/pci@1f,700000 pci108e,a801 okay 4
System PROM revisions:
----------------------
OBP 4.16.3 2004/11/05 18:29 Sun Ultra 45
OBDIAG 4.16.3 2004/11/05 18:31
To Next Page
Loading...
Need help?
General
