5-6 Sun Ultra 45 and Ultra 25 Workstations Service and Diagnostics Manual • May 2006
7. Guide the power cables out of the chassis as you push the power supply out the
back of the chassis.
Set the power supply aside on an antistatic mat.
Proceed to “Installing the Power Supply” on page 5-6.
5.2.2 Installing the Power Supply
1. Remove the new power supply from its package.
2. Align the power supply IEC-320 connector so that the power cord socket is nearest
the left rear of the chassis, when viewed from the back (
FIGURE 5-4).
To Next Page
Loading...
