xvi Sun Ultra 45 and Ultra 25 Workstations Service and Diagnostics Manual • May 2006
Chapter 6 provides procedures to finish component replacement.
Chapter 7 provides an overview of diagnostics tools and procedures.
Chapter 8 provides basic troubleshooting tasks, commands, and system responses.
Chapter 9 provides details on Solaris predictive self-healing diagnostics tools as well
as other Solaris diagnostics tools.
Chapter 10 provides information about NVRAM and changing NVRAM settings.
Chapter 11 provides diagnostics information related to power-on self-test (POST),
Chapter 11 describes OpenBoot™ Diagnostics for the Sun Ultra 45 and Ultra 25
workstations.
Chapter 12 describes the OpenBoot PROM and related tools.
Chapter 13 provides basic SunVTS™ software information and references to SunVTS
documentation.
Appendix A describes how to manage power-saving modes of the Sun Ultra 45 or
Ultra 25 workstations.
Appendix B lists the specifications of the Sun Ultra 45 and Ultra 25 workstations.
Appendix C provides a functional description of the Sun Ultra 45 and Ultra 25
workstations.
Using UNIX Commands
This document might not contain information about basic UNIX
®
commands and
procedures such as shutting down the system, booting the system, and configuring
devices. Refer to the following for this information:
■ Software documentation that you received with your system
■ Solaris Operating System documentation, which is at:
http://docs.sun.com
To Next Page
Loading...
