Contents vii
10. NVRAM 10–1
10.1 Obtaining the ok Prompt 10–2
10.2 Changing NVRAM Configuration Parameter Values 10–3
10.2.1 Displaying and Changing Parameter Values 10–3
10.2.2 Configuration Parameter Default Values 10–5
10.3 Setting NVRAM Security Mode 10–7
10.4 eeprom Command 10–9
10.5 Key Commands 10–9
10.5.1 Stop-A Key Sequence 10–10
10.5.2 Stop-N Equivalent Key Sequence Procedure 10–10
10.5.2.1 Resetting the NVRAM Temporarily 10–10
10.5.2.2 Resetting the NVRAM Permanently 10–12
10.5.2.3 Workstation Power Cycling 10–12
11. Power-On Self-Test 11–1
11.1 POST Overview 11–1
11.1.1 Configuring POST Output 11–1
11.2 post Command 11–2
11.2.1 Diagnostic Levels 11–3
11.2.2 Output Verbosity 11–3
11.3 POST Output 11–4
11.3.1 post min normal 11–4
11.3.2 post max max 11–5
11.3.3 post min min 11–13
11.3.4 post max min 11–13
11.4 Analyzing POST Messages 11–14
11.4.1 Error Messages 11–14
11.4.2 Warning Messages 11–15
11.4.3 Info Messages 11–16
To Next Page
Loading...
Need help?
General
