1/10 and 10-Gigabit Layer 2/3 Ethernet Switches User’s Manual
5-58
Stack Settings
Clicking the STACK SETTINGS tab brings up the STACK CONFIGURATION page
(Figure 5-43), which configures the stacking feature. The parameters for this page are
shown in Table 5-35.
Figure 5-43. Stack Configuration Page
Table 5-35. Stack Configuration Page Parameters
Parameter Description
Switch ID
This parameter defines a switch identifier number for this switch. This identifier
should be unique in the stack, since the number is used in referring all physical
interfaces available in this switch.
So for example, if this parameter is chosen as 2, the physical interfaces will be
referred as Gi2/1, Gi2/1 and so on.
For non-stacking, stand-alone cases this switch ID is considered as zero.
Ports
Number of stacking ports. Users can choose based on their preferred stacking
configuration and available XG ports. Stacking allowed ports are xg2 or xg3
Priority
This parameter chooses the priority for this switch in the Stacking Master
selection. It could be configured as Preferred Master, Backup Master or
Preferred Slave.
Stacking
This parameter enables or disables stacking.
NOTE: Any change in stacking status requires a reboot of the switch.
To Next Page
Loading...
