5-87
Chapter 5: Web Based Management Utility
Basic Settings
Clicking the BASIC SETTINGS tab brings up the GLOBAL CONFIGURATION page
(Figure 5-70), which can access the MSTP global configuration. The parameters for this
page are shown in Table 5-54.
Figure 5-70. Global Configuration Page
Table 5-54. Global Configuration Page Parameters
Parameter Description
Bridge Priority
This parameter specifies the Priority value assigned to the bridge that is used to
select the root bridge. The allowed value ranges from 0 to 61440. The default
priority value is 32768.
Path Cost Type
This parameter allows you to configure the path cost either as a 16-bit value or a
32-bit value. This is provided mainly for backward compatibility with STAP.
Protocol Version
This parameter specifies the protocol version number of the configuration to be
used. You can choose to run the protocol in RSTP or MSTP.
Region Name
This parameter specifies the name for the Region's configuration. By default, the
region name will be equal to the Bridge MAC Address.
Region Version
This parameter specifies the region version of the configuration to be used. The
allowed value ranges from 0 to 65535. The default value is 0.
Dynamic Path Cost
Calculation
This parameter allows you to enable or disable the Dynamic Path Cost
Calculation.
To Next Page
Loading...
