Maintenance and Lubrication: 0B-20
4) Briefly open the throttle fully and note the maximum
engine RPMs sustained during the test cycle.
CAUTION
!
Do not apply full power for more than 3
seconds or damage to the clutch or engine
may occur.
Lock-up r/min
4 000 – 5 000 r/min
Parking Brake (Brake-lock) Inspection
B705H10206040
Inspect that the wheel is locked up when pulling the
brake-lock lever 2 – 4 notches and moving the
motorcycle forward to make sure that the brake-lock acts
enough.
Parking Brake (Brake-lock) Adjustment
B705H10206041
Adjust the brake-lock in the following procedures:
1) Pull the brake-lock lever by one step (1 notch).
NOTE
The brake-lock lever have 2 – 4 steps (2 – 4
notches) when pulling in fully.
2) With the lock-nut (1) loosening, adjust the adjuster
bolt (2) in until the brake pad comes in contact with
brake disc.
3) Tighten the lock-nut (1).
4) Return the brake-lock lever to original position and
inspect the brake-lock.
CAUTION
!
After the brake-lock adjustment, inspect the
brake fluid level of rear brake.
I705H1020044-01
I705H1020045-01
I705H1020044-01
1
2
I705H1020048-01
LOWER
I705H1020033-01
To Next Page
Loading...
