Suzuki RM125 - Reassembly

KICK STARTER 8-5
REASSEMBLY
Reassemble the kick starter assembly in the reverse order of
disassembly. Pay attention to the following points:
• Apply transmission oil to the kick starter shaft.
• Install the kick starter drive gear 1 and washer to the kick
starter shaft.
• Install new snap ring.
 09900-06107: Snap ring pliers
• Insert the return spring end 2 into the hole on the kick shaft.
• Install the spring guide 3 as its groove A engages with the
return spring hooked part.
• Install the kick starter 4 to the kick starter shaft.
NOTE:
Be sure to align the punch marks on the kick starter and kick
starter shaft when installing the kick starter.