Suzuki RM125 - Reassembly

REAR SUSPENSION 17-19
• Press fit the needle roller bearing cages with the special tool.
 09913-70210: Bearing installer set
NOTE:
When installing the needle roller bearing cages, the stamped
mark on the bearing must face outside.
• Apply grease to the needle roller bearings and install them.
 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
• Press fit the needle roller bearing cages with the special tool
and a suitable size socket wrench.
 09924-84521: Bearing installer set
NOTE:
*Wh
en installing the needle roller bearing cages 2 , the
stamped mark on the bearing must face outside. (
3 : right side)
* Position the needle roller bearing cages by refering to the illus-
tration of page 17-20.
• Apply grease to the needle roller bearings and install them.
 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
REASSEMBLY
Reassemble and remount the rear suspension linkage in the
reverse order of removal and disassembly. Pay attention to the
following points:
• Position the dust seals 1 so that the manufacturer’s code
indicated side of the seals face outside. (2: inside)
• Apply grease to the spacers and dust seals.
 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)