17-14 REAR SUSPENSION
• Remove the chain buffer.
• Remove the plates.
• Remove the following parts from the swingarm.
Spacer 1
Oil seal 2
Washer 3
Thrust bearing 4
Dust seal 5
Spacer 6
INSPECTION
PIVOT SHAFT
• Measure the pivot shaft runout with the dial gauge and
V-blocks.
Swingarm pivot shaft runout
Service Limit: 0.3 mm (0.01 in)
09900-20607: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
09900-21304: V-block
CHAIN BUFFER AND CHAIN GUIDE
• Inspect the chain buffer and chain guide for damage and
excessive wear.
To Next Page
Loading...
