Suzuki RM125 - Rear Sprocket Replacement; Installation

14-8 FRONT AND REAR WHEELS
REAR SPROCKET REPLACEMENT
• Remove the rear sprocket.
NOTE:
Install the rear sprocket as the letter on the sprocket surface
faces outside.
• Tighten the bolts/nuts to the specified torque.
 Rear sprocket bolt/nut: 30 N·m (3.0 kgf-m, 21.5 lb-ft)
INSTALLATION
• Install the rear wheel, chain adjuster washers and axle shaft.
• Adjust the drive chain slack. (2-16)
• Tighten the rear axle nut to the specified torque.
 Rear axle nut: 100 N·m (10.0 kgf-m, 72.5 lb-ft)
FWD
Left
Right
Chain adjuster washer