Suzuki RM125 - Front Wheel; Removal; Inspection

FRONT AND REAR WHEELS 14-3
FRONT WHEEL
REMOVAL
• Place the motorcycle on a block to lift front wheel off the
ground.
• Remove the front axle nut 1.
• Loosen the left axle holder bolts 2.
• Loosen the right axle holder bolts 3.
• Remove the front axle shaft 4.
• Remove the front wheel.
INSPECTION
SPACER AND DUST SEAL
• Inspect the right and left wheel spacers 1 and dust seals 2
for wear and cracks.
• If any damage is found, replace the spacer together with the
dust seal.
NOTE:
Apply grease to the spacer and dust seal before reassembling.
AXLE SHAFT
• Support the axle shaft with the V-blocks and measure the axle
shaft runout.
 Axleshaft runout
Service Limit: 0.25 mm (0.010 in)
 09900-20607: Dial gauge (1/100 mm)
09900-20701: Magnetic stand
09900-21304: V-block