Suzuki RM125 - Bearing Replacement; Disc Plate Replacement

FRONT AND REAR WHEELS 14-7
BEARING REPLACEMENT
• Remove the dust seals with the special tool.
 09913-50121: Oil seal remover
• Remove the bearings with the special tools.
 09921-20240: Bearing remover set
• Remove the spacer.
• Reassemble the bearings with the special tools.
• Fit the dust seals and apply grease to their lips.
 09941-34513: Steering race installer
09913-70210: Bearing installer set
 99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
NOTE:
* Install the right side (disc side) bearing first and then the left
side bearing.
* After installing the bearings, inspect the bearings for smooth
movement.
* When installing the dust seal, place the manufacturer’s code
indicated side of the dust seal outside.
DISC PLATE REPLACEMENT
• Remove the disc plate.
• Apply THREAD LOCK SUPER to the bolts.
99000-32110: THREAD LOCK SUPER “1322”
(or equivalent thread lock)
• Tighten the bolts to the specified torque.
 Disc plate bolt: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
Left
Clearance
Right