15-16 FRONT AND REAR BRAKES
• Set the brake hose end between the hose stopper, then
tighten the brake hose union bolt 2 to the specified torque.
Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Refill brake fluid and bleed air from the brake system.
(15-3)
REAR MASTER CYLINDER REASSEMBLY
Reassemble and remount the master cylinder in the reverse
order of removal and disassembly. Pay attention to the following
points:
• Apply grease to the contact point between piston and push
rod.
99000-25010: SUZUKI SUPER GREASE “A”
(or equivalent grease)
• Set the brake hose end between the hose stopper, then
tighten the brake hose union bolt 1 to the specified torque.
Brake hose union bolt: 23 N·m (2.3 kgf-m, 16.5 lb-ft)
• Tighten the master cylinder mounting bolts 2 to the specified
torque.
Master cylinder mounting bolt:
10 N·m (1.0 kgf-m, 7.0 lb-ft)
• Install the master cylinder rod pin.
• Refill brake fluid and bleed air from the brake system.
(15-3)
CAUTION
Improper brake hose routing can damage the brake
hose.
Set the brake hose so it touches the stopper and
tighten the union bolt. Ensure the brake hose has
enough clearance to the rear suspension spring.
To Next Page
Loading...
