GEARSHIFTING 9-7
• Fit the springs 6, pins 7 and pawls 8 to the gearshift cam
driven gear 9. Wider side D of pawls should be positioned
outside.
• With the pawls held in pushed position, install the pawl lifter
0.
• Reassemble the gearshift cam driven gear and pawl lifter.
• Apply THREAD LOCK SUPER to the screws.
Retainer screw: 10 N·m (1.0 kgf-m, 7.0 lb-ft)
99000-32030: THREAD LOCK SUPER “1303”
• Reassemble the gearshift return spring A to the gearshift
shaft B properly.
09900-06107: Snap ring pliers
To Next Page
Loading...
