FRONT FORK AND STEERING 16-15
• Clamp the axle holder with a vise. Protect the axle holder with
a rag when using a vise.
• Compress the outer tube by hands and install the conrod
holder (special tool) between the axle holder bottom and lock-
nut.
09910-20115: Conrod holder
• Insert the push rod into the inner rod.
• Insert the shaped projection of center bolt into the push
rod.
• Slowly turn the center bolt clockwise until resistance is felt
and check the clearance between the lock-nut and center bolt
to provide 1 mm (0.04 in) and more.
• Turn the lock-nut counterclockwise until it contacts with the
center bolt.
• With the lock-nut held immovable using a wrench, tighten the
lock-nut/center bolt to the specified torque.
Lock-nut/center bolt: 22 N·m (2.2 kgf-m, 16.0 lb-ft)
• With the outer tube compressed by hands, remove the special
tool.
WARNING
Clamping the axle holder too tight can damage it
which will affect riding stability.
Do not clamp the axle holder too tight.
1 mm and more
(0.04 in)
1 mm and more
(0.04 in)
To Next Page
Loading...
