Suzuki RM125 - Page 243

18-16 SERVICING INFORMATION
Adjustable
range
Do not apply grease to the rubber covers.
Fit the cover positively.
Adjuster
Quick adjuster
Turn to loosen
the clutch cable tension.
Turn to loosen
the clutch cable tension.
Turn to tighten
the clutch cable tension.
Turn to tighten
the clutch cable tension.
When the movement is felt heavier,
clean this and apply grease.
Align the paint mark on the handlebars with the
mating surface of the left handlebar holder.
Apply adhesive
to inner of grip
and handlebars.
36 mm (1.4 in)
Position of magic tape : rearward
66˚
Upper side
66˚
Align the master cylinder holder
mating surface with the paint mark
on the handlebars.
190 mm (7.5 in)
Align the throttle holder
mating surface with the
paint mark on the
handlebars.
15˚
Install the throttle grip
so the “ ”mark on it aligns
with the hole throttle cable
end hooked.
30˚
55˚55˚
Upper side
Align the clutch lever holder mating surface
with the paint mark on the handlebars.
175 mm (6.9 in)
121 mm (4.8 in)
Align the “ ” mark on the left grip
with the paint mark on the handlebars.
Upper side
Upper side
151 mm (5.9 in)
151 mm (5.9 in)
151 mm (5.9 in)