Technogym EXCITE+ - Troubleshooting Menu: Led Models; Enter Password

EXCITE + - Crossover: Technical Service guide- Ver. 4.1
Page 6.2
6.1. TROUBLESHOOTING MENU: LED MODELS
Te configuration procedure is invoked when the machine is in Stand-By mode, using a different
procedure for the 500 and 700 models.
6.1.1. ACCESSING CONFIGURATION OF 500 MODELS
Simultaneously press the ENTER,
↑
, CLEAR keys. The following prompt appears on the display:
ENTER PASSWORD:
To access the procedure, type in the password 2501 which protects against unauthorized access and
press ENTER to confirm. To enter the password, increase or decrease the displayed value using the
↑
and
↓
keys, or use the +/- GOAL keys to scroll through and modify the individual digits.
At this point there are two options available:
↑
= Tech Config
↓
= Troubleshooting
Press numeric key
↓
to access the menu for configuring technical parameters; the machine display
will begin showing the current configuration, structured as in the diagram below:
6.1.2. ACCESSING CONFIGURATION OF 700 MODELS
It is invoked, when the machine is in Stand-By mode.
Simultaneously press the keys 369 for LED models. The following prompt appears on the display:
ENTER PASSWORD:
To access the procedure, type in the password 2501 which protects against unauthorized access and
press the ENTER key to confirm. At this point there are two options available:
1 = Tech Config
2 = Troubleshooting
Press numeric key 2 to access the menu for configuring technical parameters; the machine display
will begin showing the current configuration, structured as in the diagram below: