EXCITE + - Crossover: Technical Service guide- Ver. 4.1
Pagina 7.26
7.6. DISASSEMBLING THE HANDGRIPS
Figure 7.6-1
Turn off the machine and unplug the mains lead
from the wall outlet:
Carry out the procedure described in paragraph:
7.5. “Disassembling the column” and unplug the
involved cables.
1. Back off 6 screws (a)
Phillips screwdriver.
2. Remove the upper cover.
Figure 7.6-2
3. Back off the 4 screws (b) using an 8mm
hexagonal wrench.
4. Remove the handgrips.
To reassemble the handgrips,
follows the above steps in the reverse order.
CAUTION: During the reassembly
blocking the screws (b) using a torque
wrench set for 40Nm.
To Next Page
Loading...
