Technogym EXCITE+ - Disasembling the Flywheel Group; Powered Models

EXCITE + - Crossover: Technical Service guide- Ver. 4.1
Pagina 7.46
7.17. DISASEMBLING THE FLYWHEEL GROUP
7.17.1. POWERED MODELS
Figure 7.17-1
Carry out the procedure described in paragraph:
7.13. “Disassembling the Primary shaft and ” at
step(2).
1.
Disconnect the lower end of the short
connecting-rod (X), and remove the belt (Y)
from the pulley, as shown in the figure at the
side.
Figure 7.17-2
2. Disconnect all fast-
on output from the cable
(a) from the brake winding.
3. Back off the 4 screws (b)
using a 17mm
wrench, blocking the nuts on the opposite
side, with a wrench of equal size.
Continued on following page ...