5-150
5-6-13 Full Closed Loop Position Control Function
The full-closed loop refers to the system which detects the mechanical position of controlled
target by externally connected encoder and feedback it to the servo unit. If the user wishes to use
external encoder or optical ruler as the feedback signal, it is possible to achieve the connection to
control board CN8 interface; support phase A/B/Z signal (optical ruler or encoder),maximum
supported encoder resolution is 1000000 pulse/rev (pulse number of up to 4x frequency corresponded
by the full-closed loop when the motor rotates one cycle).
Servo motor
Optical ruler
Motor encoder cable
Servo motor
power cable
External encoder cable
JSSFCLxxx
Optical ruler reader
CN8
CN2
Parameter function
Pn346.0 Full-closed loop function activation
Initial Value Unit Setting Range Effective RS-485 Address
0 -- 0 ~ 1 Effective after Set 0337H
Setting Description:
Setting Description
0 Close
1 Activate
To Next Page
Loading...
