6-38
6-10 Speed reference control
Speed reference control can compensate for the influence of the following factors that cause the
system to produce overshoot
Overshoot caused by controller compensation
Overshoot caused by system delay
Overshoot caused by feedback delay
tn839.0 Speed model reference control flag
Initial Value Unit Setting Range Effective RS-485 Address
1 -- 0 ~ 1 Effective after Set
1327H
Setting description:
Setting Description
0 Disable speed model reference control
1 Enable speed model reference control
tn839.0: Speed reference control flag
tn840: Speed reference control gain
To Next Page
Loading...
