1-24
1-5 Servo Motor Installation Environment Conditions and
Methods
1-5-1 Installation Environment Conditions
• Ambient Temperature: 0 ~ + 40 °C; Ambient Humidity: 90% RH or less (without condensation
conditions).
• Storage Temperature: - 20 ~ + 60 °C; Storage Humidity: 90% RH or less (without frosting
conditions).
• Vibration: 2.5G or less.
• Places in the area of good ventilation, low moisture and dust.
• Environment without corrosive, pyrophoric gas, oil vapor, cutting fluid, cutting powder, iron
powder, etc.
• Area without water vapor and direct sunlight.
1-5-2 Installation Methods
1. Horizontal installation: To prevent water, oil and other liquids from flowing into the motor from
the motor outlet wire end; please place under the cable outlet.
Pre-cautions
2. Vertical installation: If the motor shaft is installed upwards with the reducer attached, care must
be taken to prevent the grease inside the reducer from passing through the motor shaft and into
the inside of the motor.
To Next Page
Loading...
