2
Attention
• When the servo driver is installed in the control panel, if the ambient temperature is too
high, please install a cooling fan.
• Do not conduct pressure resistance test on the Servo Driver.
• Before the machine starts to operate, confirm whether or not the emergency stop switch can
be started at any time to stop the machine.
• Before the machine starts to operate, the user parameter setting value must be coordinated
with the machine. Failure to adjust to the matched correct setting values may result in a
loss of control or failure of the machine.
• Before the machine starts to operate, make sure to confirm the parameter Cn030: serial
model settings, and select the correct Driver and Motor matching combination! Confirm
the parameter Cn001 control mode selection.
Safety Pre-cautions:
Please read this Manual thoroughly before installing, operating, maintaining, and checking. Only
a professional qualified personnel can perform assembly line work.
The safety pre-cautions in the Manual are divided into two items: “Warnings” and “Pre-
cautions”.
Warnings
:
Indicating a dangerous situation that may result in death or serious injury
of personnel if ignored.
Pre-cautions
:
Indicating a possible hazardous situation that may result in a less serious
or minor injury of personnel and damage of machinery equipment if not
resolved.
Therefore, this Technical Manual shall be read in detail before
using this Servo Driver.
To Next Page
Loading...
