TECO JSDG2S-75B-E - Page 440

7-78
Pn315.3 Electronic gear ratio takes effect immediately flag 【5-5】
Initial Value Unit Setting Range Effective Cn029 Reset
0 -- 0 ~ 1 -- --
RS-485 CANopen EtherCAT Pi Pe Pt S T
- - - -- -- O
Setting Description:
Setting Description
0 Turn off the electronic gear ratio to take effect immediately
1
Turn on the electronic gear ratio Pn306 and Pn354 to take effect
immediately
Pn316.0 Internal position command mode

【
5-4-2
】
Initial Value Unit Setting Range Effective Cn029 Reset
0 -- 0 ~ 1
★
--
RS-485 CANopen EtherCAT Pi Pe Pt S T
0316H 2310H 2310H O -- -- -- --
Setting Description:
Setting Description
0 Absolute Type Positioning
1 Relative Type Positioning
Pn316.1 Internal Position Command Hold (PHOLD) Procedure Selection

【
5-4-
2
】
Initial Value Unit Setting Range Effective Cn029 Reset
0 -- 0 ~ 1
★
--
RS-485 CANopen EtherCAT Pi Pe Pt S T
0316H 2310H 2310H O -- -- -- --
Setting Description:
Setting Description
0
After Digital Input Contact PHOLD operates, when PTRG is
triggered again, Motor will continue to complete the Internal
Position Command before PHOLD is triggered.
1
After Digital Input Contact PHOLD operates, when PTRG is
triggered again, Motor will operate according to current selected
Internal Position Command immediately.