TECO JSDG2S-75B-E - Page 467

7-105
Hn614-Hn616 DO Pin Function Operation Potential (DO-2~DO-4)

【
5-6-1
】
Hn619-Hn622
DO Pin Function Operation Potential (DO-5~DO-8)

【
5-6-1
】
Initial Value Unit Setting Range Effective Cn029 Reset
Change with
Mode
-- H0000 ~ H0119
★
--
RS-485 CANopen EtherCAT Pi Pe Pt S T
Please refer to the
Table below
Please refer to the
Table below
Please refer to the
Table below
O O O O O
Setting Description: Please refer to Hn613 Description for the Setting Method.
Parameter
Code
Parameter Name
RS-485
Communication
position
Index position
CANopen EtherCAT
Hn614 DO-2 Pin Function Planning 050EH 260EH 260EH
Hn615 DO-3 Pin Function Planning 050FH 260FH 260FH
Hn616 DO-4 Pin Function Planning 0510H 2610H 2610H
Hn619 DO-5 Pin Function Planning 0513H 2613H 2613H
Hn620 DO-6 Pin Function Planning 0514H 2614H 2614H
Hn621 DO-7 Pin Function Planning 0515H 2615H 2615H
Hn622 DO-8 Pin Function Planning 0516H 2616H 2616H
Hn617 Digital Input Contact Control Method Selection

【
5-6-1
】
Initial Value Unit Setting Range Effective Cn029 Reset
H0000 -- H0000 ~ H0FFF -- --
RS-485 CANopen EtherCAT Pi Pe Pt S T
0511H -- -- O O O O O
Setting Description: Determine the 12-bit Digital Input Contact controlled by external terminal or communication through
Bit setting method; correspond Digital Input Contacts DI-1 ~ DI-12 to the binary 0th ~ 11th bits
individually first, then convert the binary bits completed planning into hexadecimal for setting.
Binary Bit Representation: 0: Digital Input Contact is controlled by an External terminal.
1: Digital Input Contacts is controlled by communications.