Options and Accessories
Introduction
This section lists the instrument options and accessories that were available
at the time this manual was published. To obtain additional information
about these and other options and accessories, refer to a current Tektronix
Product Catalog or contact your local Tektronix Field Office or representa
tive.
Options A1-A5 International Power Cords
Instruments are shipped with the detachable power-cord option as ordered
by the customer. Descriptive information about the international power-
cord options is provided in Section 2 “ Preparation for Use." Order power
cords only by option number and description. The optional power cords
available for the 2245A are as follows:
Standard, North American 120 V, 60 Hz, 74 in.
Option A1, Universal Euro 220 V, 50 Hz, 2.5 m
Option A2, UK 240 V, 50 Hz, 2.5 m
Option A3, Australian 240 V, 50 Hz, 2.5 m
Option A4, North American 220 V, 50 Hz, 2.5 m
Option A5, Switzerland 220 V, 50 Hz, 2.5 m
Option 15
The 2245A Option 15 oscilloscope provides two additional output signals
from the rear of the instrument: a Channel 2 output signal and an A GATE
output signal. The following paragraphs give a more detailed description of
both of these outputs. Specifications and Performance Checks are inte
grated into the appropriate sections of this manual.
CH 2 Signal Output—Connector located on the rear-panel provides an out
put signal that is a normalized representation of the Channel 2 input signal.
The output amplitude into a 1 M f l load is approximately 20 mV per division
of input signal. Into a 50 f l load, the output amplitude is approximately 10
mV per division of input signal.
A GATE Output—Connector located on the rear-panel provides a TTL and
CMOS compatible, positive-going gate signal that is HI during the A Sweep
and LO when the A Sweep is not running.
2245A Operators
8-1
To Next Page
Loading...
