Operators Familiarization
Configure M enu
The CONFIGURE item allows you to select whether or not to keep the
readout on in the single-sequence trigger mode.
Select CONFIGURE from the SERVICE MENU and answer YES or NO to
each of the displayed questions. Either YES or NO will be underlined to indi
cate how the instrument is presently configured. After YES or NO is se
lected, the next configuration choice is displayed. After answering the last
question, the SERVICE MENU display returns. To exit from the CONFIG
URE menu without answering the remaining question(s), press the END
button or the CLEAR DISPLAY button. The CONFIGURE items are listed as
follows:
NOTE
Instruments Serial Numbered B020099 or below only have
one menu Item in CONFIGURE: KEEP MENU ON WHEN
MEAS'MT SELECTED?
KEEP MENU ON WHEN MEAS’ MT SELECTED? (Factory Settings de
fault is NO.) Selecting NO clears the measurement menu items from the
display after a measurement function is selected. Measurement cursors
remain displayed. The AUTO TRACKING MENU remains on after a selec
tion has been made.
Selecting YES allows a measurement menu to remain displayed after a
function is selected. The measurement menu items can be removed at any
time by pressing the CLEAR DISPLAY button once.
PRESET TV TRIG SLOPE FOR -SYNC? (Factory Settings default is
YES.) Selecting YES will cause the trigger slopes to preset to when TV
trig mode is selected, and the configure menu is exited. If NO is selected, a
second question is presented.
PRESET TV TRIG SLOPE FOR +SYNC? (Factory Settings default is NO.)
Selecting YES will cause the trigger slopes to preset to “+” when TV trig
mode is selected, and the configure menu is exited. If NO is selected, the
scope will not use a preset slope when a TV trig mode is selected.
3-10
2245A Operators
To Next Page
Loading...
