Tektronix 7613 User Manual

VOLTAGES AND WAVEFORMS
The voltages and waveforms shown on this diagram were obtained by using the recommended test equipment and test
set-ups listed below.
RECOMMENDED TEST EQUIPMENT
ITEM SPECIFICATIONS RECOMMENDED TYPE
Oscilloscope Frequency response DC to 65 MHz Tektronix 7603 or 7613 equipped with
Deflection factor 5 mV to5V/Div | 7A15A Amplifier and 7B50 Time-Base
Input impedance 10 MQ, 20 pF unit, or equivalent.
Sweep rate 500 ns
Probe Fast rise 10X attenuation probe com- | Tektronix P6053A, or equivalent.
patible with the vertical amplifier of the
test oscilloscope.
Voltmeter (Non-Loading Input impedance 10 MQ Tektronix 7D13 Digital Multimeter (test
Digital Multimeter) Range — 0-500 V oscilloscope must have readout system)
or Fairchild Model 7050, or equivalent.
Voltage Measurements Waveforms
Voltage
measurements
on
this
diagram
were
made
under
Waveforms
shown
on
this
diagram
were
obtained
under
the following conditions: the following conditions:
7613 OSCILLOSCOPE UNDER TEST. Front panel
controls are set the same as for voltage measurements. A
7A15AN Vertical plug-in unit and a 7B53AN Time Base
unit are installed in the mainframe under test. The 4
Set VERT MODE for CHOP Volt Calibration signal from the mainframe under test
isconnected to the input of the vertical amplifier. The
vertical amplifier is set for 1V/Division deflection
Set front panel controls (knob type) to mid-range.
Set
TRIG
SOURCE
for
VERT
MODE
centered
on
the
CRT.
The
7B53AN
is
set
for
free
running
sweep;
1
ms/Division
sweep
rate.
Set
for
NON
STORE
condition
TEST
OSCILLOSCOPE.
The
test
oscilloscope
is
AC
coupled and internally triggered.
No
plug-in
units
are
installed.
Tolerances
of
voltages
and
waveforms
shown
are
20%.
Voltmeter common is connected to chassis ground.
7613

Tektronix 7613 Specifications

General

Brand	Tektronix
Model	7613
Category	Test Equipment
Language	English