Tektronix 7613 User Manual

VOLTAGES AND WAVEFORMS
The voltages and waveforms shown on this diagram were obtained using the recommended test equipment and test set-ups
listed below.
RECOMMENDED TEST EQUIPMENT
ITEM SPECIFICATIONS RECOMMENDED TYPE
Oscilloscope Frequency response DC to 65 MHz Tektronix 7603 or 7613 equipped with
Deflection factor 5 mV to5 V/Div | 7A22 Amplifier and 7B50 Time-Base
input impedance 10 MQ, 20 pF unit, or equivalent.
Sweep rate 500 ns
Probe Fast rise 10X attenuation probe com- | Tektronix P6053A, or equivalent.
patible with the vertical amplifier of the
test oscilloscope.
Voltmeter (Non-Loading Input impedance 10 MQ Tektronix 7D13 Digital Multimeter (test
Digital Multimeter) Range 0-500 V oscilloscope must have readout system}
or Fairchild Model 7050, or equivalent.
Calibration Fixture Used for loading power supply for ripple | Tektronix Signal Standardizer, Tektronix
waveforms. Part Number 067-0587-01, or equivalent.
Voltage Measurements Waveforms
Voltage measurements on this diagram were made under Waveforms shown on this diagram were obtained under
the following conditions: the following conditions:
7613 OSCILLOSCOPE UNDER TEST. Front panel
controls are set the same as for voltage measurements. A
signal standardizer plug-in unit is installed in the vertical
plug-in position and a 7B53AN Time Base unit in a
horizontal position. The signal standardizer plug-in unit
Turn
READOUT
to
off.
is
used
for
power
supply
loading
and
is
set
for
AUX
IN
with a REP RATE of 100 Hz. No signal is applied. The
7B53AN is set for free running sweep of 1 ms/Division.
TEST OSCILLOSCOPE. The test oscilloscope is AC
coupled and set for LINE trigger. A 7A22 Vertical
Set knob type front panel controls (except READ-
OUT) to mid-range.
Set VERT MODE for CHOP.
Set for NON STORE condition. plug-in unit is installed and set as follows:
HF —3 dB POINT 30 kHz
Set
TRIG
SOURCE
for
VERT
MODE.
LF
—3
dB
POINT
DC
+INPUT AC
—INPUT GND
No plug-ins are installed.
Voltmeter common is connected to chassis ground. Tolerances of voltages and waveforms shown are 20%.
7613

Tektronix 7613 Specifications

General

Brand	Tektronix
Model	7613
Category	Test Equipment
Language	English