Setting the record length
Use this procedure to set the record length. The record length sets how many
samples (data points) are added to a waveform record. Available record lengths
are 1000, 2000, 20,000 points.
1. Push Acquire.
2. Push the Record Length side-menu button.
3. Use the Multipurpose knob to select and set the record length.
Use longer record lengths to either capture more samples for a waveform record,
or capture more cycles of a waveform, then use the Zoom controls to investigate
the waveform in more detail.
Acquisition setup
74 TBS1000C Series Oscilloscopes User Manual
To Next Page
Loading...
